CDA FW253 Manual

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : se

10Setting the TemperatureYou must allow the fridge to settle for at least twenty four hours prior to switching the power on. The thermostat automatic

11UseFridge• Never put liquids in the refrigerator uncovered.• Never put hot foods in the refrigerator. Warm food should be allowed to cool to room

12Ice BoxThe ice box door should be kept closed to prevent the contents of the ice-box defrosting, heavy build up of frost in the ice-box and excessiv

13Storing Frozen Food Products• When shopping, leave frozen food purchases until last and transport products in a thermally insulated cool bag.• O

14Care and CleaningAlways disconnect the appliance from the power supply before any cleaning or maintenance.The fridge sections should be cleaned usin

15g. 1Defrosting the FridgeThe fridge is self-defrosting. Any water created will run out of the fridge through the channel at the back of the fridge.

16Changing the Light BulbDisconnect the appliance from the power.• Carefully remove the light cover by pushing in the lever at the back of the cover

17• The door is closing properly.• The cooling system at the rear of the appliance is clean and free of dust, and not touching the rear wall.• The

18g. 2g. 3 KIT 123456 9 10 78910InstallationThis appliance must never be installed close to heat sources i.e. heating elements, radiators, cookers

19g. 6g. 4g. 5600min 550820- 890595548min 25819- 889100- 1705611111111Fig. 4 - Dimensions of the applianceFig. 5 - Fitting the worktop bracketRemov

2

20g. 9Fig. 7 - Adjusting the appliance heightThe height of the appliance can be adjusted by the help of adjustable feet to fit the furniture height.

21Fig. 10 - Fitting the decor door bracketUnscrew and remove the nuts and washers from the appliance door. Place fixing bracket on the appliance door

22Fig. 12 - Fitting the decor doorPlace the decor door onto the appliance door by inserting adjustment bolts into the slots on the fixing bracket. Loc

23g. 154Fig. 15 - Fitting the decorative coverFit the decorative cover (4) on the decor door fixing bracket.Fig. 16 - Fitting the plinthFit the plinth

24Reversing the DoorIt is possible to reverse the door on this appliance, if required. To do so, follow the steps below:1. Open the door.2. Loosen t

255. Rotate the ice box door 180° and secure in position by fitting the bottom hinge on the left side using the screw removed in step 3.6. Refit the d

26cut o and disposed of safely to prevent the risk of electric shock. A suitable alternative plug of at least 13 Amp rating to BS 1363 should be use

27NOTES

Please contact our Customer Care Department, or for Service on the details below.Customer Care Department • The Group Ltd. • Harby Road • Lang

3Contentspage 4 Importantpage 6 General Warningspage 8 Importantpage 9 Before First Use page 10 Setting the Temperaturepage 11 Usep

4ImportantThe CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note tha

5(Low voltage) and requirements of EMC Directive 2004/108/EEC.This appliance has been manufactured to the strictest standards and complies with all ap

6General WarningsWARNING: Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of obstruction.WARNING: Do n

7persons in order to avoid a hazard.• This appliance is not intended for use by persons (including children) with reduced physical, sensory or menta

8ImportantNever store inflammable or explosive items and strong corrosive acids or alkalis in the appliance.This is a household appliance, which is pro

9Before First UseYou must allow the fridge to settle for at least twenty four hours prior to switching the power on.It is recommended that you clean t