CDA FW971 Manual download pdf (Page 18)

Fitting the product

into the cabinet

1. Remove the gasket protection

pieces:

The gasket protectors prevent

excessive seal compression during

transport and are required during

the installation process. Remove the

gasket protector from each door (ﬁg

5) and proceed with the installation.

Cover caps are provided to ﬁll the

hole; take care when inserting

these.

2. Fitting the top xing brackets:

Secure the two top ﬁxing brackets

to the top of the product using two

screws for each bracket, as shown

in (ﬁg 6) (a).

3. Fitting the front shelf trim:

Note: The front shelf trim is

mounted for transit inside the

fridge at the back left. This must

be removed from the transit

location before the fridge is

switched on.

The front shelf trim ﬁts to the top of

the unit by hooking into slots on the

ﬁg. 5

ﬁg. 6

ﬁg. 7

ﬁg. 8

Width spacer

(One to be ﬁtted

top each hinge

when 15mm

cabinets are

used)

Door protection

piece being used

as a guide.

Guide piece simply slotted

in to the ﬁxing bracket

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 29 30

No comments

CDA FW971 Manual Page 18