Cda DV 990 User Manual download pdf (Page 47)

Electrical Installation

For your safety please read the following information:

WARNING! Before effecting any intervention on the electrical parts the appliance must be

disconnected from the network.

IMPORTANT: The oven must be installed in accordance with the manufacturer’s instructions.

Incorrect installation, for which the manufacturer accepts no responsibility, may cause

damage to persons, animals and things.

General

– The connection to the electrical network must be carried out by qualiﬁed personnel and must be

according to existing norms.

– The appliance must be connected to the electrical network verifying above all that the voltage

corresponds to the value indicated on the speciﬁcations plate and that the cables section of the electrical

plant can bear the load which is also indicated on the plate.

– The appliance can be connected directly to the mains placing an omnipolar switch with minimum

opening between the contacts of 3 mm between the appliance and the mains.

– The power supply cable must not touch the hot parts and must be positioned so that it does not exceed

75°C at any point.

– Once the appliance has been installed, the switch must always be accessible.

– If the power supply cable is damaged it must be substituted by a suitable cable.

IMPORTANT: this double oven must be connected to a suitable double pole control unit

adjacent to the oven.

NO DIVERSITY CAN BE APPLIED TO THIS CONTROL UNIT.

The connection of

the appliance to the

grounding unit is

mandatory.

The manufacturer

declines every

responsability for

any inconvenience

resulting from the

inobservance of this

condition.

Feeder Cable Section

Type H05RR-F or H05VV-F

230 V~ 3 x 2.5 mm

(**)

(**) – Connection to wall-mounting distribution panel.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52

No comments

Cda DV 990 User Manual Page 47