CDA ECHK90 User Manual

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 003 E : cu

10your hob being disconnected from the gas supply and the installation being reported to RIDDOR (The height should be measured from the top of the bur

11InstallationNote• Werecommendthatyouseekthehelp of another individual when installing this product.• Thexingssuppliedaresuitablefo

12Fig. 9calculation shown below for your extractor (refer to fig 4):A = Height of gas hob burner or electric hotplate height from the kitchen floorB =

13be at least the minimum height specified)5. Place the chimney section over the body assembly, as shown in fig 8.6. With the help of another individ

14Mains Electricity ConnectionTHIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT PERSON, USING FIXED WIRING VIA A DOUBLE POLE SWITCHE

15NOTE: USE A 3A FUSEAssembly and electrical connection should be carried out by competent personnel.When installing this product we recommend you see

16TroubleshootingIf your extractor is not working:1. Check that the mains supply has not been switched o.2. Check that the fuse in the spur has n

17

18

19

2ImportantThe CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note tha

Please contact our Customer Care Department, or for Service on the details below.Customer Care Department • The Group Ltd. • Harby Road • Lang

3safety (LVD) and Electromagnetic interference compatibility (EMC). IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DI

4• This extractor has been designed to be used in a room with a volume of less than 36 m.• Steam cleaners must not be used when cleaning this appl

5Using your ExtractorFor best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately

6Care and MaintenanceIMPORTANT: DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.Cleaning Yo

7position to prevent damage from other items in the dishwasher. After rinsing and drying, replace the filters. To remove the grease filters, pull open t

8Changing the LightIMPORTANT: DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY. DO NOT CHANG

9Bulb replacement is not covered by the guarantee.Only use bulbs recommended for your extractor. Do not fit bulbs of a higher power rating. Bulbs of a