CDA 9Z6 Owner's Manual download pdf (Page 11)

9-EN

Blackout Mode On and Off

When the Blackout mode is turned on, the display

will turn off to reduce power consumption.

This additional power enhances the sound quality.

1 Press and hold the BLACK OUT button for at

least 2 seconds to start the blackout mode. By

doing so the display will be removed.

NOTE

If any button on the unit is pressed during the blackout

mode, the function will be displayed for 5 seconds to

show the operation before returning to Blackout mode.

To cancel the blackout mode, press and hold the

BLACK OUT button for at least 2 seconds.

Switching the Display Modes

1 Press the DISP (DISPLAY) button to select the

desired Display pattern mode.

Each press changes the display patterns.

Pattern

Description

Normal pattern (Upward)

Mode Display

(Keeps showing the present operation

over and over.)

Normal pattern (Rightward)

Demonstration Display

Scan Display

(Repeats from Pattern 1 to Pattern 4

for every 5 seconds endlessly.)

Mode Display

Display OFF

Adjusting the built-in Audio

Processor

You can change High Pass Filter, Low Pass Filter,

and Sub Woofer Phase on this unit, so that you

can create your favorite sound effects.

1 Press and hold the A.PROC button for at least 3

seconds to enter Adjust Mode.

2 Within 5 seconds, press the DN g or f UP

button repeatedly to select the desired

parameter.

→ HPF → LPF∗ → SUB-W∗

∗ When the subwoofer is turned OFF by using

this unit, LPF and phase are deactivated.

3 Rotate the Audio Control knob to select the

desired setting.

1. HPF (Setting the High Pass Filter):

→ OFF ← → 63Hz ← → 80Hz ←→100Hz ←

→ 200Hz ← → 160Hz← → 125Hz ←

Outputs all frequencies higher than that selected

according to your preference.

2. LPF(Setting the Low Pass Filter):

→ OFF ← → 63Hz ← → 80Hz ←→100Hz ←

→ 200Hz ← → 160Hz← → 125Hz←

Outputs all frequencies lower than that selected

according to your preference.

(Only available when using the subwoofer output

from this unit.)

3. SUB-W (Change the Subwoofer Phase):

NORMAL ↔ REVERS

You can change the subwoofer phase.

(Only available when using the subwoofer output

from this unit.)

NOTES

• If the battery is disconnected, all settings return to

factory default.

• If no buttons are pressed within 5 seconds, the setup

menu returns to the normal audio display.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Comments to this Manuals

No comments

CDA 9Z6 Owner's Manual Page 11

Comments to this Manuals