CDA EVM9 Manual

EVM9 ExtractorsManual for Installation, Use and MaintenanceCustomer Care Department • The Group Ltd. • Harby Road • Langar

9Using the extractor as an extraction deviceWork out the required height of the optional chimney for your ceiling and mount the chimney xing bracket

10Attribute Symbol Value UnitsModel Identification evm9Annual Energy Consumption AECHood139.0 kWhTime increase factor f 1.5Fluid Dynamic Efficiency FD

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949

ImportantThe manufacturer cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that

2Using your ExtractorFor best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately

3Care and MaintenanceIMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.Cleaning Y

4Fig. 5Changing the LightIMPORTANT: DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.DO NOT

5DOUBLE POLE SWITCHED FUSED SPUR OUTLETUSE A 3 AMP FUSEMains Electricity ConnectionTHIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT

6InstallationYour extractor can be used to lter and recycle the air within your kitchen, or to extract the air outside. When extracting air to the ou

7Fitting your extractor to the wallNext, remove the top cover by loosening the screws (b), closing the front panel and then lifting the cover o.The e

8Fitting your extractor to the wallInsert the 4 wall plugs in to the holes and x 2 screws in the top holes so that they are protruding from the wall