CDA EVQ7 Manual

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 00

9

10

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 00

ImportantThe manufacturer cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that

Using your ExtractorFor best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately

Care and MaintenanceIMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.Cleaning Yo

4Changing the LightDO NOT CHANGE THE LIGHT BULB IMMEDIATELY AFTER USE AS THE BULB WILL BE HOT. ALLOW IT TO COOL BEFORE REMOVING IT.Remove the light bu

5DOUBLE POLE SWITCHED FUSED SPUR OUTLETUSE A 3 AMP FUSEMains Electricity ConnectionTHIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT

6InstallationYour extractor can be used to filter and recycle the air within your kitchen as shown in fig 5, or to extract the air outside as shown in fi

7FITTING YOUR EXTRACTOR TO THE WALL:Before commencing, remove the grease filter as shown above.The extractor is mounted to the wall using 4 screws. Ens

8