CDA WC140 Manual download pdf (Page 23)

Troubleshooting

Problem Possible cause

The programme will not start

Check the plug, fuse and circuit breakers of the mains

supply.

The water tap is turned o.

The dishwasher door is not fully closed.

The water inlet ﬁlter or the machine ﬁlters are blocked.

Water remains inside the dishwasher at the end of a

programme

The water drain hose is blocked or kinked.

The ﬁlters are blocked.

The dishwasher stops in the middle of a programme

Power failure.

Water inlet failure.

Programme is on standby.

Wash performance is of a low standard

Poor loading of dishes hinders wash performance.

Insucient detergent added.

Inappropriate wash programme selected.

Spray arm is blocked.

Filters clogged or incorrectly ﬁtted.

Water drain pump is blocked.

White stains on the dishes

Insucient detergent added.

Rinse aid setting is too low.

Insucient dishwasher salt added.

Water softener setting is too low.

Salt compartment cap may not be completely closed.

The dishes are not completely dry at the end of a

programme

A programme without a drying stage was selected.

Rinse aid setting is too low.

Dishes unloaded too soon (allow time for drying).

There are rust stains on the dishes

Dierent sets of cutlery should be kept separate.

Too much salt (water softener setting is too high).

Salt compartment cap not completely closed.

Poor appliance earth (check mains electrical supply).

The door is not opening or closing properly Door tension not correctly adjusted for the decor door.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28

No comments

CDA WC140 Manual Page 23