Cda HVC 32 User Manual

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 00

10How To Turn the Touch Control ON and OFFSwitching ONPress the key and keep it pressed until the touch control is lighted.The displays of the cookin

11Power Ignition and Adjustment of a Cooking ZoneTo turn ON a cooking zone the touch control must be switched ON (see section “How To Turn t

12Fast Automatic Heating of the Cooking ZonesThis function permits fast heating up at the maximum power level, followed by heating at the preset

13Safety Key-Lock to Protect ChildrenThis function locks the touch-control keys against unwanted activation.To activate the key-lock press

14Program for Automatic Switching OFF of One Cooking ZoneThis function permits to set a timer from 1 to 99 minutes for automatic turning OFF of on

15Operation Time Limit of Cooking ZonesEach cooking zone is automatically switched OFF after a maximum preset time if no operation is performed.The m

16Error Code on the Display/sIf an error message appears on the display/s (the display/s show/s " F " and another character alternating - e.

17Cleaning and MaintenanceCleaning the Ceramic Hob– Remove spillages and other types of incrustations.– Dust or food particles can be removed with a d

18TIPS FOR INSTALLATIONInstallationCAUTION:This appliance shall only be serviced by authorised personnel.– This appliance is to be installed only by

19This cooktop can be built into a working surface 20 to 40 mm thick and 600 mm deep.In order to install the ceramic hob into the kitchen fixture, a h

2ImportantThis appliance is designed and manufactured solely for the cooking of domestic (household) food and is not suitable for any non domest

20Fastening the CooktopEach cooktop is supplied with a set of tabs and screws to fasten it on units with a working surface from 2 to 4 cm deep. The ki

21Mains Electricity ConnectionIncorrect installation may be dangerous and the manufacturer can not be held responsible.Warning! This appliance must be

22Connection of the Power Supply CableUnhook the terminal board cover by inserting a screwdriver into the two hooks A (fig. 13).Open the cable gland

23Appliance ServicingCDA provide a quality and effective after-sales service to cover all your servicing needs. Please attach your receipt to this pag

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 00

3Before Using for the First Time– Read the instructions carefully before installing and using the appliance.– After unpacking the appliance, make sur

41234 7 8 6 5Features and Technical DataCooking Zones1. Hi-light cooking zone Ø 140 mm - 1200 W2. Double hi-light cooking zone Ø 180/120 mm - 1700/700

5Cooking Zones FeaturesThe ceramic surface of the hob allows a fast transmission of heat in the vertical direction, from the heating elements undernea

6After a short period of use, experience will teach you which setting is the right one for your needs.Cooking Hints = Warming = Cooking =

7Residual Heat IndicatorsWhen the temperature of a cooking plate is above 65°C, the relevant H in the touch control display is also lit-up (with the

8Safety Hints– Before you switch the hob on, make sure you know which control keys control the required cooking zone. We advise you to set

9How to Use the Touch-ControlNotes:– Each selection (by pressing one of the keys) is indicated by an acoustic signal (beep).– If the e