CDA FWV460 User Manual download pdf (Page 7)

Troubleshooting

If no water is dispensed when the buttons are pressed, it is possible that an air

bubble may have formed in the pipe. This can be caused when the pipes are

emptied, for example during the cleaning process.

To remove an air bubble:

1. Put an absorbent cloth or a towel beneath the water nozzle.

2. Squeeze the pump provided to remove the air inside the pump.

3. Insert the end of the pump into the water nozzle.

4. Press

, then release the pump to draw the air bubble out.

If necessary, repeat steps 2-4 above.

IMPORTANT:

Do not operate with a damaged cord, plug, after the appliance malfunctions

or has been damaged in any way. You should contact CDA Customer care for

inspection, repair or adjustment.

Problem Solution:

WATER MISSING shows in the display

The water tank is empty and needs to be reﬁlled

ICE FAULT WATER READY shows in the display

at ﬁrst switch on

Turn the icemaker off with

and the main switch on the side, before

switching it on again.

The icemaker emits a continuous beep UV Sterilizer needs replacing - contact CDA Customer Care

The dispensed water has an unpleasant taste Ensure that only water pipes suitable for drinking water are used

ICE FAULT shows in the display

Turn the icemaker off with

remove some ice and turn it on again.

We recommend that the unit is not left on permanently.

ﬁg. 2

1 2 3 4 5 6 7 8 9 10 11 12

No comments

CDA FWV460 User Manual Page 7