Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 00
Install your extractorTo Install your extractor, proceed as follows: -4. Connect the ventilation ducting to the duct pipe in the ceiling void and
Install your extractorTo Install your extractor, proceed as follows: -6. Locate the lower decorative section in position and slide the upper secti
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HYT : 01949 862 012 F : 01949 862 00
ImportantThe CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please note that
Using your ExtractorFor best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for approximately
Care and MaintenanceIMPORTANT : DO NOT PERFORM MAINTENANCE OR CLEANING OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY SUPPLY.Cleaning Yo
Changing the LightDO NOT CHANGE THE LIGHT BULB IMMEDIATELY AFTER USE AS THE BULB WILL BE HOT. ALLOW IT TO COOL BEFORE REMOVING IT.Remove the grease fil
DOUBLE POLE SWITCHED FUSED SPUR OUTLETUSE A 3 AMP FUSEMains Electricity ConnectionTHIS APPLIANCE MUST BE CONNECTED TO THE MAINS SUPPLY BY A COMPETENT
Electrical InformationMains electrical voltage: 230 – 240VacTotal rated power consumption: ECPK9:470WTroubleshootingPlease note:Your extractor is eq
Mounting your ExtractorIMPORTANT:We recommend that you seek the help of another individual when installing this productThe minimum ceiling height when
Install your extractorTo Install your extractor, proceed as follows: -1. Mark and drill holes in the ceiling for the four support plugs, using eit
Comments to this Manuals