Installing the CDA 7 5330 with Microcode Release 5264
77 A7 48UU Rev03 E-15
E.3.6 Setting the Modem Parameters
To set the Modem parameters:
1. Under the SYMM4 prompt, enter the following command:
C:\SYMM4> scsetup
The following dialog box is displayed.
SymmCom Target Configuration
Is Symmetrix attached to an
Ethernet LAN for use as its
communication mode ? (Y/N)
Modem
Comm Port
Port Rate
Connectivity
Encryption
Call Back disabled
Prefix if any to access an
outide line
Generate Configuration
Multitech MULTIMODEM
COM (3F8 hex- IRQ4)
19200
Allowed
OFF
Y
Figure E-11. Modem Parameter Setting
2. At first installation, change the password. This password is generally
G70xxx, where xxx are the three last digits of the serial number of the CDA 7
subsystem.
3. Answer N to the first message: CDA 7 5330 is not attached to an Ethernet
LAN. The Make a Model window is displayed.
4. Enter N. Successive dialog boxes are displayed.
Comments to this Manuals